Электронный каталог НБ БНТУ

Статья

Multi-objective optimization of process parameters of multi-step shaft formed with cross wedge rolling based on orthogonal test / S. T. Han [et al.]. – DOI 10.1088/1757-899X/372/1/012044 // IOP Conference Series: Materials Science and Engineering. – 2018. – Vol.372 №1. – Article number 012044. - Журнала нет в фонде библиотеки. – Пер. загл.: [Многоцелевая оптимизация технологических параметров многоступенчатого вала, формованного поперечно-клиновой прокаткой, на основе ортогональных испытаний]. – На англ. яз.

In order to achieve reasonable process parameters in forming multi-step shaft by cross wedge rolling, the research studied the rolling-forming process multi-step shaft on the DEFORM-3D finite element software. The interactive orthogonal experiment was used to study the effect of the eight parameters, the first section shrinkage rate φ1, the first forming angle α1, the first spreading angle β1, the first spreading length L1, the second section shrinkage rate φ2, the second forming angle α2, the second spreading angle β2 and the second spreading length L2, on the quality of shaft end and the microstructure uniformity. By using the fuzzy mathematics comprehensive evaluation method and the extreme difference analysis, the influence degree of the process parameters on the quality of the multi-step shaft is obtained: β2>φ2>L1>α1>β1>φ1>α2>L2. The results of the study can provide guidance for obtaining multi-stepped shaft with high mechanical properties and achieving near net forming without stub bar in cross wedge rolling.

621.771

общий = БД Труды научных работников БНТУ : 2018г.
труды сотрудников БНТУ = Научно-технологический парк БНТУ "Политехник"
труды сотрудников БНТУ = Металлообработка. Термообработка (труды)
общий = ПОПЕРЕЧНО-КЛИНОВАЯ ПРОКАТКА
общий = ОПТИМИЗАЦИЯ
общий = ТЕХНОЛОГИЧЕСКИЕ ПАРАМЕТРЫ
общий = ТЕХНИЧЕСКИЕ ВАЛЫ